Round Transvectors
PDF documentation
Round Transvectors are ideal for conveying any material that can be moved in an airflow and for removing fumes and scrap. Since air amplifiers move large volumes of air using only a small amount of compressed air, they are economical to operate.
- Models and Specifications
- Round Airflow Amplifiers (aluminum body)
- Round Airflow Amplifiers (stainless steel body)
- Energy Saving Jets
High volume air amplifiers for conveying and removing fumes and scrap
When the vacuum from an electric motor blower proved ineffective, a label manufacturer opted for the strong suction of a model 904 Round Transvector to pull away paper trim scrap from a die cutting operation.
A facility produciing plastic body side moldings for the automotive industry increased production by installing two model 903 Transvector air amplifiers - one to remove moisture after a water bath, and the second to pull away edge trim for recycling.
Each welding station at a wrought iron furniture assembly plant is equipped with model 904 Transvectors to ventilate smoke and fumes.
- Applications
- Tech notes
- Most searched products
- Transvector Airflow Amplifier (throat 40 mm)
- Transvector Airflow Amplifier (20 mm throat)
- Transvector Airflow Amplifier (throat 20 mm)
Applications:
Round Transvectors are used in both ducted and unducted applications. In ducted applications, they are used at flow rates up to 2400 SCFM (67920 SLPM). Transvectors are excellent for ventilating, air conveying, drying and cooling.
Features and Benefits:
- No moving parts, maintenance free
- Airflow and output easily adjusted
- No electricity, explosion hazard or RF interference
- Significantly smaller and less expensive than variable-speed blowers or fans
- No guards or safety hazards
- Instant on/off
- Quiet - meets OSHA noise requirements
- Easily mountes, ducted and moved
- Move air at atmospheric pressure without air locks
- Outperform venturis and ejectors
Uses:
- Conveying any material that can be moved in an airflow including grain, plastic pellets, sawdust, powder, capsules, metal chips, paper and cloth trim, lint, dust, small parts, stamping scrap and lead shot
- Ventilating and exhausting welding, soldering and machine smoke, auto exhaust, plating tank fumes and other gases
- Cooling molded parts, castings etc.
- [ Site map ]
Vortex Italia
Via Dante, 83 - 20031 Cesano Maderno (MB)
Tel: +39 0362 54 56 45
Info tecniche: +39 335 61 68 653
Fax: +39 0362 60 99 62
P. Iva: 02651900967
E-mail: info@vortexitalia.com